Baby Quilts And Alternative Ways To Obtain Your Baby To Sleep
I then sewed all the squares together, in an alternating pattern. I now had the quilt top. I used soft fleece for the backing and put a piece of quilt batting in between the two. I found that if you spray an adhesive on the quilt batting it helped to keep the pieces from shifting too much. After pinning the quilt, I sewed a dark blue blanket binding around the outside edge. All that was left was to tie it. I used 6 strand embroidery floss, and hand knotted every corner except the corners at the blanket binding.
The best bed you can make for your Retriever inside the house is with a woolen blanket - an old one - and keep its meal and water, close by all the time. If inside the house and sleeping with you in your bedroom, well, you better be prepared to get up twice or thrice to take it outdoors for it to answer nature's call. You will get used to it, and so will your pet! You bet!
Blanket Quilt Double-Sided Bias Tape. You'll use this to make the trim. There are other ways to do it, but this is one of the easiest, and will give your baby quilt a nice, finished look. Try to pick bias tape that compliments the fabric. For example, if your fabric has a pattern, pick one color in the pattern and choose bias tape to match. If you want the bias tape to sort of blend in, try to match the fabric's background color.
Continue sewing additional fabric rectangles to sides 3, LeoBedding 4 and 5 of the center piece. Note that new angles can be created as you go, and excess length can be cut off. Trim any rectangles that extend beyond the foundation fabric even with the edge of the foundation fabric.
Place a few straight pins at random places on the surface of the quilt. (Anywhere but on the lines.) This will keep the pieces from shifting during sewing.
This caused most families to start saving bits and pieces of scrap material. It was not uncommon to see bins of random materials scattered in small piles of the early colonial homes as they hoped to gather enough to eventually construct a quilt.
I scanned the photos and then printed them onto photo transfer sheets. I ironed the transfer on to a piece of white material that was just a little bit larger than the picture. The white square and photo was sewn on top of one of the 12" blue squares. I then added eyelet trim and blue ribbon around each photo. Putting dark blue ribbon on a light blue square, and light blue ribbon on a dark blue square.
A century ago, cigar companies tied a bright colored silk ribbon around a bundle of cigars. Women stitched them together with black or colored embroidery floss stitches onto a fabric foundation block. They were not cut or curved, but placed side by side. Cigar company ribbons had fancy logos and used attractive fonts in black ink on yellow or orange ribbons. The various advertising on the ribbons added decoration to the quilt block. Green, pink and purple ribbons were occasionally used in the block designs, signifying a rare cigar.
