Baby Linens In Your Nursery

Using a sewing machine, sew along the lines. For each line, start at the top of the fabric, as close to the edge as you can get. When you reach the bottom, sew a little past the edge.

First decide on the finished foundation (muslin) size for each block and cut the muslin one half inch larger than the desired finished block size. This allows for any puckering or tight tension variations that could draw up the size. You can always cut the finished piece down to the proper size later. Also remember that the finished block size in this case is the unfinished block size for your quilt. You will have to have a seam allowance to sew your blocks together into a quilt. A half inch should provide this necessary allowance.

Blanket Quilt When you store your handmade quilt in a closet or drawer, if you feel the need to wrap it up in something, use tissue paper rather than a plastic bag. Storing it in a plastic bag for a long period of time may result in yellowing and discoloration.

Use the tailor's chalk to draw lines connecting the marks at the bottom of the fabric to the marks at the top. You want the lines to be as straight as possible. To achieve this, take something long and flat (like a long piece of cardboard) and use it as a guide while you draw the lines.

The method above uses machine embroidery on relatively small quilts. Larger quilts can be done the same way or may be quilted with machine embroidery by individual quilt blocks. Experiment to decide which method is easiest for you and remember that the machine embroidery quilting method may change with each unique project.

After the foundation piece has been completely filled with fabric strips, trim the block to the desired size. Press the block on both the front and back. Don't leave any loose pieces.

Now use a steam iron to turn and press the rectangle over the seam allowance, pressing away from the center piece. Trim the seam allowance close to the stitching line to remove the bulk in your design.

These 4 pieces of quilt frame were then placed on top of a kitchen chair and tied with, you guessed it, old sheet that had been torn from worn out bed sheets. Then a clamp was placed in each corner to keep the right angle of the frame in place and checked often with the square my father used for building the baby cribs, beds and toddler beds.